The blade gap of the shearing machine can not be adjusted by anyone. It is not a professional who does not adjust it by himself. If you are nervous, it depends on whether your machine is adjusted after the knife is changed or the maintenance adjustment. If it is completely messed up, then you have to step by step. Gradually.
First, adjust the indicator to 50 filaments, restart to isolate one grid and adjust it with a feeler gauge, re-adjust the other one that has not been adjusted, and finally adjust the knife-edge indicator to zero. At this time, fine mediation was done. At this time, you have to ensure that the three wires can enter the five wires at the zero position.
I remember that he always pulls one screw or two screws at the same time. Be careful, otherwise you will bite the knife. As for the cutting angle of the blade, this skill requires greater than the gap. Spend a little money to let a professional adjust it. Otherwise, the entire blade is scrapped. The blade gap can be adjusted normally, and the black and white of the blade is planned. You can't adjust.
If the black and white of the knife is too large or too small, it is not good. This angle is determined at the planned time. If the black and white of the pendulum shears cannot be adjusted, the guillotine can be adjusted. Only the guillotine shears can adjust the black and white of the knife As usual, there is a button to increase or decrease on the control panel. If it is not easy to operate, it can be resolved by closing the ball valve of the main cylinder, then pressing the adjustment button to increase or decrease, and then release the ball valve.
