For the machine equipment of the shearing machine, it can also be said to be a commonly used mechanical equipment, because it is used in mechanical processing. Moreover, it is still one of the important products and main keywords in the website. Therefore, it must be understood and understood, and it must be comprehensive and deep, rather than just on the surface. Then, under this specific requirement, we will continue this work in order to speed up the learning process.
1. Is there any difference between QC12K and QC11Y in the shearing machine?
Shears have different models and specifications, and each of them is different. For example, the two models QC12K and QC11Y are different, because QC12 is a hydraulic pendulum shear, and QC11 is a hydraulic guillotine shear. Moreover, K is a numerical control type, and Y is a normal hydraulic type. Therefore, there will be this conclusion.
2. If a nitrogen cylinder is used in the shearing machine, what is the pressure?
In the shearing machine, if a nitrogen cylinder is used, the operation is to find the interface on the nitrogen cylinder, then connect it with a high-pressure pipe, and then open the valve on the bottle until the pressure is 6 to 7 MPa. At this time, close the valve and stop using the nitrogen cylinder. Therefore, its pressure is 6 to 7 MPa.
3. Is there a difference between the carbon steel and stainless steel with a shearing machine?
The shearing machine cuts carbon steel and stainless steel differently. Although both of these are metal materials, the strength of stainless steel is larger. Therefore, it is embodied in the shearing machine, and the same equipment is the specification of carbon steel, which can be larger.
4. Can the gap between the upper and lower blades of the hydraulic pendulum shears be adjusted by the mechanism?
Hydraulic pendulum shears, the gap between the upper and lower knives can be adjusted by the mechanism. Specifically, it is for adjusting the operating mechanism to adjust the gap size. However, to be specific, we need to look at the process requirements and the type of material, because if the amount is different, then there are different gap ratios.
