The rust prevention of the parts of the shearing machine is very important. The maintenance of the hydraulic components of the hydraulic guillotine shears is an important thing. In order to maintain the cleanliness of the hydraulic system, the hydraulic components should be maintained on schedule thing. The main hydraulic components of hydraulic guillotine shears include hydraulic circuits, oil filters, air filters and hydraulic pumps. Then, how to maintain these components of the hydraulic system:
A. Hydraulic circuit
This is to avoid hydraulic pump failure due to lack of oil in the hydraulic system. The oil level of the hydraulic guillotine shears oil tank should be checked on time. If the oil level is lower than the middle line of the oil mark, refuel to the middle line of the oil mark at an emergency speed. In addition, after 500 hours of application, an oil change is required. In the future, the oil must be changed after every 2000 hours. The hydraulic oil pressure of the hydraulic shears must meet the requirements of the hydraulic shears. Wash the oil tank of the hydraulic guillotine shears every time the oil is changed.
B. Oil filter
The cleaning of the oil filter must be done in place. Regularly clean the oil leaker installed at the end of the oil pump oil inlet of the hydraulic guillotine shearing machine, and clean it with a solution such as gasoline or trichloroethylene. cast
Into the application of hydraulic guillotine shears, it is washed once 8 days later, and it can be washed once every 30 days afterwards. If the oil filter assembly of the hydraulic guillotine shears is severely damaged, it must be replaced in time.
C. Air filter
Clean the air filter regularly. The air filter is normally installed on the oil tank of the hydraulic guillotine shears. Generally, the hydraulic guillotine shearing machine should be washed once after 500 hours after it is put into use. It should be washed with gasoline, vinyl chloride and other solutions. In the future, it should be washed once every 1000 hours of application.
D. Hydraulic pump
This should fully do the maintenance and work of the hydraulic pump used in the hydraulic system of the hydraulic guillotine shears.
It is very important to do a good job of daily protection. It is necessary to prevent the parts of the shearing machine from rust, and to reduce the wrong requirements in the use of the equipment, so as to strengthen the later use.
